Roughneck Jackman Fusion Equipment, Руководство оператора

Страница: 32 / 52

JACKMAN FUSION EQUIP – ELECTROFUSION PROCESSOR OPERATORS MANUAL - REV 0
Page 30 of 48
APPENDIX
Scanning Barcodes
SMART Scanner ™
THE SMART SCANNER™ IS NOT MULTI LINGUAL. THE ONLY LANGUAGE AVAILABLE IS ENGLISH.
Smart Scan Mode
To operate the SMART Scanner ™ in Smart Scan Mode, set the SMART SCANNER option in the Basic
User Menu to “YES”. In Smart Scan mode, additional features not available in Scan Mode can be used.
Smart Scan Mode allows you to:
•
View fitting data on the SMART Scanner™ screen before beginning a fusion.
•
START and STOP a fusion using the SMART Scanner™ button.
•
Scan Pipe/Fitting Traceability barcodes.
When operating in Smart Scan Mode, the SMART Scanner™ will provide operator feedback on the
display to assist in the completion of the fusion without getting in and out of the ditch. When the
SMART
Scanner™ is powered up in Smart Scan Mode, the display will look something like this:
CONNECT FITTING
The processor is now ready for you to connect the Output Lead Ends to the fitting. Once you connect
the fitting, the display will look something like this:
PRESS BUTTON
TO SCAN
The processor is now ready for you to scan the fitting barcode and Pipe/Fitting Traceability barcodes (if
enabled). See the Scanning Techniques section on page 32 for tips on how to reliably scan a barcode.
Once the barcode has been successfully scanned, the fitting information will be shown on the display.
It could look something like this:
CPL 2 ” COUPL
60 sec START?
This should be the same data that is displayed on the screen of the processor and is an indication that
the fusion is ready to be started. At this point in time the fusion can be started by pressing and holding
the
button on the SMART Scanner™ for a few seconds. As the fusion is in progress , the SMART
Scanner ™ display will look something like this:
FUSION IN PROCESS
Press Button to STOP
At any time, you may press and hold the button to stop the fusion.