22. Reduce speed on slopes and sharp turns to minimise tipping or loss of control. Be
careful when changing directions on slopes. Do not start or stop suddenly on slopes.
Avoid operation on steep slopes.
23. When using a unit, a minimum 20% of tractor and equipment weight must be on
tractor front wheels. Without this weight, tractor could tip over, causing personal
injury or death. The weight may be attained with a front end loader, front wheel
weights, ballast in tires or front tractor weights. When attaining a minimum 20% of
tractor and equipment weight on the front wheels, you must not exceed the
ROPS
weight certification. Weigh the tractor and equipment. Do not guess or estimate!
24. Inspect the entire machine periodically
3
. Look for loose fasteners, worn or broken
parts.
25. Use only the driveline supplied with the machine. Do not use it if it is missing any
shield or safety protection.
26. Pass diagonally through sharp dips and avoid sharp drops to prevent “hanging up”
tractor and machine.
27. Avoid sudden starts and stops while travelling up or downhill.
28. Always use down slopes; never across the face. Avoid operation on steep slopes.
Slow down on sharp turns and slopes to prevent tipping and or loss of control.
3.02 - Set-up
Notice to dealer:
pre-delivery set-up and service including lubrication is the
responsibility of the authorised dealer. It is up to you to assure that the machine is in
perfect condition and ready to be used. It is your responsibility to ensure that the
customer is aware of all safety aspects and operational procedures for the machine.
You must also fill out the Pre-delivery Checklist
4
prior to delivering the machine.
CAUTION: stand clear of bands when cutting as they could be under sufficient
tension to cause them to fly loose. Take care in removing bands and wire. They
often have extremely sharp edges and cut very easily.
Although the machine usually arrives set up, ready to use, it is important to check
certain aspects of the machine before using it. Adjustments are normally necessary in
order to adapt the Green-Rite to work under a given condition.
Check the oil in the gearbox. The proper level should be between
1
/
2
and
2
/
3
full. Use 90
wt. or 140 wt. gear oil. Make sure the breather cap is clear and tight in the gearbox.
Check all hardware for tightness, especially the bolts holding the 3 point hitch
5
.
Grease the cross and bearings and the telescopic tubes of the driveline.
Ensure that the drive chains are well greased, both the tiller drive chain in the chain
housing on the left side
(see fig. 16)
as well as the roller chain which drives the hopper
O
PERATION
12
R
OTOMEC
G
REEN
-R
ITE
O
PERATOR
’
S
M
ANUAL
5
See table 4, page 32.
4
See chapter 7 - Pre-delivery Checklist.
3
See chapter 4 - Maintenance.