Every 8 hours:
1.
grease the rotor support (see fig. 15) and the roller support (see fig. 17), the
driveline cross & bearings and telescopic tubes.
Apply two or three shots of
grease to the driveline cross and bearings and the telescoping shafts. Apply the
same amount to the rotor and roller bearings. See the driveline manufacturer
operator’s manual for further information on the driveline.
2.
Gearbox oil level:
check gearbox oil level, it should be between
1
/
2
and
2
/
3
full. If
needed add either
SAE
90 wt. or
SAE
140 wt. gear oil.
Whenever the hopper is used for fertiliser spreading it is extremely important to
carefully clean out the hopper and wash the machine with hot water. Do not
forget that fertiliser is highly corrosive and should be not left in the hopper any
longer than necessary.
M
AINTENANCE
31
R
OTOMEC
G
REEN
-R
ITE
O
PERATOR
’
S
M
ANUAL
1
2
3
4
Fig. 16
1. chain case grease access plug
2. chain case
3. stand
4. side plate
1
2
3
4
Fig. 17
1. greasing the roller support
2. rear roller
3. tickler tines
4. roller adjustment turnbuckle
