2.02 - Starting and Stopping
1. Be sure that no one is near the machine prior to engaging or while the machine is
working.
2. Be sure the tractor is in “Neutral” before starting engine.
3. Equipment operating power is supplied from tractor
PTO
. Refer to your tractor
manual for
PTO
engagement and disengagement instructions. Always operate
PTO
at 540 rpm. Know how to stop the tractor and machine quickly in case of an
emergency.
4. When engaging
PTO
, the engine rpm should always be low. Once engaged and
ready to start working, raise
PTO
speed to 540 rpm and maintain throughout
operation.
5. Check the tractor master shield over the
PTO
stub shaft. Make sure it is in good
condition and fastened securely to the tractor. Purchase a new shield if old shield is
damaged or missing.
6. After striking an obstacle, disengage the
PTO
, shut the tractor down and thoroughly
inspect for damage before restarting.
7. Never engage the
PTO
until the machine is in the down position and resting on the
ground. Never raise the machine until the rotor has come to a complete stop.
2.03 - Messages and Signs
1. Read and adhere to all safety and operating decals on this machine
(see fig. 2)
.
2. Before dismounting tractor: allow moving parts to stop, stop engine, set brake and
remove the key of unattended equipment.
3. Keep away from rotating blades and driveline.
4. Keep guards and shields in place and in good condition.
5. Do not use with bystanders in area.
6. Allow no riders on tractor or machine.
7. Allow moving parts to stop before repair.
8. Securely support equipment before working underneath.
Additional warning and operating decals are available at no extra charge. Please specify
model and serial number when ordering.
S
AFETY
P
RECAUTIONS
8
R
OTOMEC
G
REEN
-R
ITE
O
PERATOR
’
S
M
ANUAL
