Rosslare AYC-W6500, Инструкция по установке и эксплуатации

Страница: 36 / 66

Controller Functionality
AYC-W6500 Installation Manual Page 35
ion.
er
cted to the PS-Cx5T/TU or PS-Ax5T/TU intelligent
power e door without the
ors.
t is
put
k
•
EX button is
5.7 PS
The AYC-W Ax5T/TU intelligent
power to Exit (REX) input.
ormed solely via the unit's keypad,
using a
tings are referred to here as "Default Factory
Settings".
Clear the tamper event by entering a valid Employee or Test Code that
will open the Lock Strike Output in the current mode of operat
For example, while in Secure mode, using the Test Codes to clear a
tamper event does not work because the Test Codes do not work in
Secure mode. However, applying a Secure Code will clear the tamp
event in Secure mode.
5.6 Request to Exit (REX) Function
The REX button is conne
supply unit. The REX button is used to open th
use of a PIN code and must be located inside the secured premises.
For example, a REX button may be located inside the door or at a
receptionist's desk, where authorized personnel can grant entry to visit
The function of the REX button depends on whether the Lock outpu
programmed for Fail Secure Operation or Fail Safe Operation.
• Fail Secure Operation: From the moment the REX button is
pressed, the door will be unlocked until the Lock out
Release Time has passed. After this time, the door will re-loc
even if the REX button has not been released.
Fail Safe Operation: From the moment the REX button is
pressed, the door will be unlocked. When the R
released, the controller waits a for the duration set as the Lock
Output Release Time, and then re-locks.
-Ax5T/TU or PS-Cx5T/TU Units
6500 must be used with the PS-Cx5T/TU or PS-
supplies, which provide Lock output and Request
The supplies include a speaker for bell and siren functionality. The unit
signal from the keypad used for the bell is also used for the door-opened
chime.
Both units communicate through a proprietary Rosslare protocol, which
provides a secure link between the controller and the power supply unit.
This in turn activates the door unlocking. For more information see the PS-
Cx5T/TU or PS-Ax5T/TU manuals.
5.8 Programming the AYC-W6500
Programming the AYC-W6500 is perf
built-in Programming Menu System.
To reach the Programming Menu System, first place the AYC-W6500 into
Programming Mode.
During manufacturing, certain codes and settings are pre-programmed
into the unit. These set