Rose electronics UC1-1X16U/E, Инструкция по установке и эксплуатации

Страница: 76 / 80

70
ULTRACONSOLE USERS MANUAL
Kernel halt error messages
Message Description
BAD Address = nn Kernel memory is corrupt, hardware failure.
Resetting to factory
defaults A memory error is detected during a read
from configuration memory. This also
indicates a hardware failure, but the system
may continue to initialize successfully. The
configuration from another Unit should be
saved to this Unit as soon as possible.
Unit Halted A major error has forced the kernel to stop
processing. The UltraConsole waits to
receive a kernel or main firmware file from
the bottom board’s serial port using the serial
parameters: 9600, N, 8, 1. Connect the serial
cable supplied with the UltraConsole as
described in the Serial Port section, start a
terminal emulator and transfer the file using
an ASCII file transfer protocol.
Kernel is bad, load
new kernel through
serial port. The UltraConsole waits to receive a kernel or
main firmware file from the bottom board’s
serial port using the serial parameters: 9600,
N, 8, 1. Connect the serial cable supplied
with the UltraConsole as described in the
Serial Port Section, start a terminal emulator
and transfer the file using an ASCII file
transfer protocol.
Checksum error
The kernel writes this message at power up
when a memory error is detected during a
read from program memory.