Rose electronics UC1-1X16U/E, Инструкция по установке и эксплуатации

Страница: 21 / 80

ULTRACONSOLE USERS MANUAL
15
To start, identify the following prior to installation:
1. Which UltraConsole will be #1, #2, and so on
2. Which computer will be #1, #2, and so on
3. Which computers do not use a PC2 keyboard or a PS/2 mouse
4. Which Unit and CPU port each computer will be connected to
5. The “Starting computer” number for each Unit
6. The number of computers, or “Maximum computers”, that the
UltraConsole will be managing
The “Starting computer” and “Maximum computers” values are
determined as follows:
Starting computer
The “Starting computer” number will depend on which Unit is being
configured. The “Starting computer” number for the first Unit is always
one (default). Using Units that have 16 CPU ports, the “Starting
computer” number for the second Unit is the total number of CPU ports
on the first Unit + one or 17, the third Unit would have a “Starting
computer” number of 33 (Total CPU ports on unit #1 and unit #2 + 1,
and so on.
Maximum computers
The “Maximum computers” value is calculated by counting the total
number of CPU ports on all units. If your system consists of 10
UltraConsole Units, each with 16 CPU ports, the “Maximum computers”
number would be 160. The “Maximum computers” value must be
entered from a KVM station and when saved, this value is propagated
to all connected Units.
Connecting the expansion units
The installation steps below are for all UltraConsole models.
Steps:
(NOTE: Expansion cables should not be connected at this point)
1. Verify that power is “OFF” on all UltraConsole switches.
2. Configure the “Starting computer” number for all the UltraConsole
switches, starting with Unit #2 by: (Unit #1 default = 1)
a. Connect a KVM station to Unit #2’s KVM connector using the
appropriate KVM adapter cable.
b. Apply power to the KVM monitor and to UltraConsole #2.
c. When the internal diagnostic completes, press and release the
left control [Ctrl] key, then the F12 key to display the “Main
menu”.
d. Select “System” and press [Enter].