Rose electronics UC1-1X16U/E, Инструкция по установке и эксплуатации

Страница: 19 / 80

ULTRACONSOLE USERS MANUAL
13
6. Verify that the keyboard, video, and mouse on the connected
computer function properly before proceeding.
7. Switch the KVM station to the next sequential CPU port (step 3) and
perform steps 4-6 for the remaining computers.
8. When all computers are connected and operating properly, change
the “Maximum computers” value from the default value of 64 to the
correct number of computers connected to the single Unit. This will
limit the scanning function to the actual number of computers that
are connected. Change the “Maximum computers” value as
follows:
(See page 15 for determining the “Maximum computers” value.)
a. Call up the main menu ([Ctrl], F12). (Figure 5)
b. Select “System” and press [Enter]. (Figure 6)
c.
Select “Maximum computers” and press [Enter].
d. Enter the correct “Maximum computers” value and press
[Enter].
e. Press [ESC] to return to the main menu.
f.
Save the changes and EXIT. (Figure 14)
This completes the basic installation for a single Unit. You can switch
to any of the attached computers from the keyboard by pressing and
releasing the left control [Ctrl] key, typing in the computer port number
to switch to and press [Enter]. You can also switch to a computer by
displaying the “Computer select” menu (left control [Ctrl] key, then
press the [ESC] key). Select the computer to switch to from the list and
press [Enter]. You will be immediately switched to that computer.
(Figure 16).
To customize the configuration settings for the system, computers,
KVM station, users, profiles, groups, and language see the
Configuration Menu section for details.
Refer to the Operation section for information on the operation of the
UltraConsole switch.