Rose electronics UC1-1X16U/E, Инструкция по установке и эксплуатации

Страница: 23 / 80

ULTRACONSOLE USERS MANUAL
17
7. Apply power to the next unit to bus in, then connect an expansion
cable (IN THIS ORDER);
From: Unit #2’s “OUT” expansion card connector
To: Unit #1’s “IN” expansion card connector.
(Connecting the expansion cable from the “IN” connector first to the
“OUT” connector can cause termination conflicts and require power
to be cycled on all units.
8. Verify that the block of system CPU ports from Unit #2 is
recognized on the status screen. If Unit #2 is a 16-port switch,
computers 17–20, 21–24, 25–28, and 29–32 will be highlighted.
9. Sequentially apply power, then connect the expansion cables to the
remaining switches as explained in steps 7 and 8. Always with
power on the unit and from the “OUT” connector of the Unit being
added to the “IN” connector of the previously installed Unit.
10. When all Bus cabling is in place and reporting properly to the status
screen, save the configuration to update all boards in the system.
Verifying the Video path
Steps 11, 12, and 13 verify that the video path is properly routed to a
KVM station and all “BUS” cabling is connected properly. Make sure all
UltraConsole switches are on, all Bus cabling is in place and a KVM
station is connected to UltraConsole #1’s KVM port.
11. Connect an IBM compatible computer to any CPU port on the last
UltraConsole switch. Switch the KVM station to this CPU port by
pressing and releasing the left control [Ctrl] key, type in the CPU
port number, then press [Enter]. This connects the KVM station to
that CPU port.
12. Boot the computer; you should see the boot-up sequence on the
KVM monitor. If no video is seen, see the troubleshooting section.
13. Connect other KVM stations, if needed, to the UltraConsole
switches and verify they operate properly. (See Appendix F)
Connecting the computers
If power must be maintained on a computer, perform steps 4a-e on
page 12 to pre-configure the keyboard and mouse types, if needed,
before connecting the computers. Though not required, the following
steps assume that all CPU ports will be utilized and the computers
installed sequentially.
(All UltraConsole switches in the system should have power “ON” and
no configuration menu displaying on the KVM monitor.)