Roland VersaSTUDIO BN-20A, Руководство пользователя

Страница: 89 / 120

Is the media loaded and set up straight and securely?
Feed is not smooth when the media is not straight or is tensioned unevenly on the left and right. Re-
load the media.
RELATED LINKS
・
P. 20 "Loading Media"
Was loaded media allowed to stand for some time?
Media may shrink or wrinkle if it is heated for an extended time. When printing ends, press and hold
down the [POWER] key to switch off the sub power or remove the media.
Was the media loaded while the heater was hot?
Loading media after the heater has warmed up causes the temperature of the media to rise suddenly,
which may cause the media to shrink or wrinkle during printing. Before loading media, switch off the
sub power and allow the platen to cool.
Is the temperature of room too low?
Use this machine in an environment having an ambient temperature of 20 to 32°C (68 to 90°F). If the
machine is used at an ambient temperature less than 20°C, then depending on the type or width of
the media, wrinkling or temperature-caused unevenness may occur. To obtain stable printing results,
the machine should be used at an ambient temperature of 20 to 32°C (68 to 90°F).
Is the humidity of the room too high?
Use this machine in the environment of 35 to 80 %RH (non condensation).
Is the using media deflected?
If using the deflected media, it cause winkle of the media.
Media Wrinkles or Shrinks
88
Media Feed Problems