Roland VersaSTUDIO BN-20A, Руководство пользователя

Страница: 107 / 120

Operation cannot be continued. By following the messages displayed in the Utility window, remove the
media, close the front cover, and then hold down the [POWER] key to switch the sub power off. This
error may be caused by such factors as an incorrect loading of the media, a media jam, or an opera-
tion that pulls the media with excessive force. Eliminate the cause of the error before switching the
sub power on, and then reload the media.
[Waste cartridge is estimated to be full]
Output is stopped because the waste cartridge is full.
Output cannot be resumed without correcting this error. Replace the waste cartridge with a new one
by following the message displayed in the Utility window. If a new waste cartridge is not available for
immediate replacement, switch the main power off.
[Temperature error]
The temperature of the location where the machine is installed has risen above or fallen below the
ambient temperature at which the machine can operate.
Operation cannot be continued. Switch off the sub power. Bring the installed location to a tempera-
ture at which operation is possible (20 to 32°C) and allow the machine to come to room temperature,
then turn on the power.
[Cover open error.]
Output is stopped because the front cover or the maintenance cover is open.
Start output again after closing the cover.
[Sheet setup error]
Setup of the media has failed. Load the media correctly.
RELATED LINKS
・
P. 20 "Loading Media"
[Data error]
Output was stopped because a problem was found in the data received.
Operation cannot be continued. Check for errors in the data. Check for a problem with the connector
cable or the computer, and start output again.
[Ink has run out.]
Output is stopped because ink has run out.
In the [Ink] tab of the Utility window, check the color of the cartridge that has run out of ink, and
replace the ink cartridge with a new one.
RELATED LINKS
・
P. 60 "Checking Ink Levels"
・
P. 61 "How to Replace Ink Cartridges"
[Pinch lever was returned.]
Output is stopped because the loading lever is pushed backward while output is in progress.
Pushing the loading lever backward cancels the setup of the media, so output is stopped. Reload the
media.
Error Messages
106
Handling Messages and Error Messages