Roland Stika SV-12, Руководство пользователя

Страница: 41 / 64

4-1 Optimizing the Cutting Quality for the Material
Chapter 4: Mastering the STIKA 39
Adjusting the Blade Extension Amount
CAUTION Do not touch the tip of the blade with your fingers.
Doing so may result in injury.
Procedure
➊
Turn the machine off.
Loosen the screw, remove the blade holder.
➋
Adjust the blade extension amount.
Turn the tip of the blade holder as indicated in the fig-
ure to extend the blade tip. Turn the large cap once to
extend the blade tip by 0.1mm.
➌
Support the screw from below and insert the
blade holder.
➍
Tighten the screw.
Tug the blade holder upward to make sure it does not
come loose.
➎
Carry out the cutting test and check the cutting quality for the material.
Repeat until optimal cutting quality is attained.
☞
p 38 "Check the Cutting Quality for the Material"
Rough Estimate for the Amount of Blade Extension
Use the following dimension as a rough estimate for setting the amount of blade extension.
* Suggested point
The optimal setting has been achieved when there are
faint lines on the backing paper when a cutting test is
executed.
Blade holder
0.1 mm
Screw
The blade tip essentially
cannot be seen from the
blade holder.
Support the
screw from
below.
Tight contact
Screw
Material
portion
Backing paper
portion
Blade
Holder
Amount of blade is
approximately equal
to cutting-in amount
Amount of blade
extension
=
Thickness of the
media portion
Thickness of the
backing paper
2
+
Half of the
backing paper