Roland Stika SV-12, Руководство пользователя

Страница: 38 / 64

3-2 Cutting
36 Chapter 3: Performing Cutting
Step 4: Apply the Cut Material
Use application tape to affix the cut material. Cut the application tape to the required size for use.
Before applying, thoroughly clean the surface where you want to affix the material to remove any dust or grease.
Procedure
➊
Remove the excess tape so that only text re-
mains.
Use a commercially-available tweezers to remove small
pieces of tape better .
➋
Cut the application tape to the required size.
Cover the cut material flush with the applica-
tion tape to prevent any air from getting under-
neath, then transfer the material.
You can transfer the material easily by using a com-
mercially available squeegee or the flat part of a ruler
or the like to rub the cut material from above the ap-
plication tape.
➌
Affix the material together with the joined ap-
plication tape to the target object, then press
down on it from above.
➍
Make sure the material is affixed to the object,
then slowly peel off the application tape.
If air becomes trapped between the material and the
application surface, forming an air bubble, then use a
needle to pop the bubble and press out the air to form
a complete seal.
➎
This completes the procedure for attaching the
material.
Material After Cutting
Transfer the cut material to the application tape and affix it to the object as soon as possible. Any dust that builds
up on the surface of the material can make it difficult for the application tape to stick.
Application tape