Roland Color CAMM PC-50, Руководство пользователя

Страница: 16 / 25

14
6 To Perform Long Printing/Cutting
6
Feed out the length
of material to be
printed or cut.
Make sure that the material
remains held by the pinch
rollers.
If the material does come
loose from the pinch rollers,
set it in place again.
7
Return the fed-out
material.
5
Press the SETUP
key.
8
6 To Perform Long Printing/Cutting
3
4
2
1
Pull out the material from the roll and
pass it through the unit.
Material
alignment
stickers
25 mm
(1")
or more
Use material that is wider by 50 mm (2") or more than
the width of the printing or cutting to be performed.
Pull out the amount of
roll material to be used.
After finishing the
setup for the material,
send the data from
the computer.
Material
alignment
stickers
Guide line
Guide line
25 mm
(1")
or more
When performing printing or cutting over a length of 1.5 m (60") or more, first feed out the required length of material. Then
follow the steps below to load the material.