Roland Color CAMM PC-50, Руководство пользователя

Страница: 14 / 25

12
5-8 Moving the Base Point for Printing or Cutting
The BASE POINT SET key can be used to move the base point for printing or cutting.
Use all areas of the material effectively, without waste.
5 Basic Operation
1
The carriage moves to the new base point.
< Example >
NEW BASE POINT
2
Press the BASE POINT SET key.
The BASE POINT SET
LED lights up
* If the base point has been
moved, the sheet-width value
for the Windows driver should
be entered again.
If this value is not corrected,
output results may be cut off
before reaching their normal
end.
Rear
Front
H
NEW BASE POINT
W
Enter this value
1 2
* Note that an area of approximately 2 square centimeters (a little less than a square inch) is
required to make a test cut.
Use the , , , and
keys to move the tool
carriage to the position on
the material where the
cutting test is to be executed.
Cutting test starts.
1) First peel off the round section (shaded as shown ).
When it can be peeled by itself, without disturbing the square, the cutter force is set
appropriately.
2) Next, peel off the square, and look at the backing behind it.
The optimum blade pressure is correct if you can clearly make out the lines left by the blade.
Adjust the cutter force control slider until results as shown above are obtained.
(Gradually increase the cutter force until you reach the optimum level.)
3
Then peel
this off
Peel off first
Press the TEST key.
Origin (when
using roll material)
5-9 Cutting Test to Check Cutter Force
Before cutting, you may wish to perform a “cutting test” to learn whether the unit cut satisfactorily. If cutting is to be continued on the
same material, there is no need to perform a cutting test.
Move the cutter force control slider all the way to the left (minimum cutter force).