Roland Camm-1 PNC-1200, Руководство пользователя

Страница: 41 / 53

35
If the message
appears on the display
This is displayed when the sheet type is selected on the “SELECT SHEET” menu, and the movable pinch rollers (left
and right) are lifted.
Check that a sheet is loaded, lift the sheet loading lever, and lower the left and right movable pinch rollers. When the movable
pinch rollers are lowered, the display message will change to “SELECT SHEET.”
If the message
appears on the display
the location of one or more of the pinch rollers is not correct.
If this happens, raise the sheet loading levers and move the pinch rollers to the proper positions above the grit rollers.
Reposition the sheet to match this new alignment, then lower the sheet loading levers to hold the sheet in place.
If the message
appears on the display
This is displayed when the sheet type is selected on the “SELECT SHEET” menu, and the front cover opened.
Close the front cover and the display message will change to “SELECT SHEET.”
If the message
appears on the display
This is displayed when the front cover is opened during cutting. Cutting operation is halted, and the message is
displayed on the screen.
To clear the error, turn off the power. Even if the front cover is closed again, cutting will not be repeated unless the power is
turned off and then back on again. For cutting of interrupted data use the following procedure
1) Turn the power off and back on again to clear the error, and check that cutter and sheet are correctly mounted.
2) Refer to Setting the origin point “Setting the origin point” on page 25, and set the origin where you wish to cut.
3) Send a cut command from the computer to start cutting.
If the message
appears on the display
Shows motor error status.
This is displayed when the PNC-1850/1200 is heavily loaded, such as during a paper jam, when heavy stock is cut across a
long distance without initial sheet feed, or when the sheet is abruptly pulled from the roll during cutting.
In this case, turn the power off and back on again (if a paper jam has occurred, clear the jam before turning the power back
on).
For large cutting data with a roll sheet, use the “AREA” function on the display menu to feed the roll sheet by the length of
the cut (ensure a small margin by setting a length that is about 0.1 m longer than the cutting data).
When using heavy stock, set the display menu “WEIGHT” to “HEAVY” (see “SHEET WEIGHT Cutting thicker sheets” on
page 25).
If the above message is displayed even after “WEIGHT” is set to “HEAVY,” turn the power off and then back on again, and
reduce the “**cm/s” value in the display menu. See “** cm/s Setting cutting speed” on page 23.
PINCH ROLLER UP
COVER OPEN
Change Pinch
Roller Position
COVER OPEN
Power ON Again
Motor Error
Power ON Again