Roland Camm-1 PNC-1200, Руководство пользователя, Страница: 17 / 53

11
Loading the sheet from the front of the PNC-1850/1200
(When sufficient space cannot be maintained at the back surface of the main body)
(1) With reference to the provided PNS-185/121 ASSEMBLY INSTRUCTIONS, mount the PNC-1850/1200 on the stand. One
sheet hanger should be at the front of the PNC-1850/1200 (the opposite position from the normal set position).
(2) Mount the two shafts included with the stand on the sheet hanger and place a rolled sheet on top of the shafts.
(The shafts (2 pieces), stoppers (2 pieces), and stopper retaining screws (2 pieces) are included with the stand.)
Stopper
Pass the stoppers onto
the shaft.
If the diameter of the rolled
sheet core is 72 mm (2-7/8") or less
Install the shaft here if the amount
of sheet remaining is small.
Shafts
* One shaft should always be
installed here.
Install the shafts to match either
the remaining amount (roll width)
of the sheet, or the diameter of
the rolled sheet’s core.
* Do not use with shafts installed
at both of these positions at the
same time.
Rear
Front
Sheet hangers
Tighten the stopper
retaining screws
provisionally.
Rear
Front
Shafts
Place the rolled
sheet here.
(3) Pull out as much from the roll as needed, and pass
the sheet from the front of the PNC-1850/1200 to
the back as shown in the figure.
At this time, pull the sheet straight out, so that the
left and right sides of the sheet are parallel to the
legs of the stand.
Make sure that the edge of the sheet lies above the
grit rollers. Also check to make sure that the left
and right pinch rollers can be moved to the left and
right edges of the sheet.
Pull out the sheet so that it is parallel to the stand legs
Rolled Sheet
Pass between the pinch roller
and grit rollers
Pull out so that there is
no slack on either side.
Front
Move the pinch
rollers to inside
the edges of the
sheet
Stickers showing the locations of the
grit rollers
Make sure the left and right margins are the same size
Sheet
(4) Move the two pinch rollers so that they are close
to the left and right edges of the sheet. When
doing this, make sure that the pinch rollers are
positioned above the grit rollers.
Three stickers indicating the locations of the grit
rollers are affixed to the back surface of the front
cover. You can use these stickers to confirm the
locations of the grit rollers when the grit rollers are
hidden by the sheet.
If the pinch rollers are difficult to move, try
moving the sheet loading lever on the back of the
unit at the same time.
Before attempting to move the
pinch roller, be sure to lower
the sheet loading lever.