Roland Camm-1 PNC-1200, Руководство пользователя

Страница: 20 / 53

14
Press
MENU
.
(8)
PROTOCOL 1
STOP DATA PARITY
PROTOCOL 2
BAUD HANDSHAKE
AREA AXIS
REPLOT SUBMENU
COMMAND I/O
UNIT END
Use or to select.
Press
ENTER
.
Use or to select.
Press
ENTER
.
Press
MENU
twice.
(3), (4)
(5)
(6)
(7)
Use or to select.
Press
ENTER
.
WEIGHT UPSPEED
SMOOTH CALIB
INTERFACE
PARA SERI<AUTO>
(1) Set the output port for the computer (or software) to “Parallel” for a parallel
connection, or to “Serial” or “RS-232C” for a serial connection.
* The method used to make this setting varies according to the software
used. For details, refer to the manual for your software.
(2) Close the front cover.
(3) Press the
MENU
key to display the menu shown at right.
(4) Use the and keys to move the blinking cursor to “SUBMENU” and press
ENTER .
(5) Press the
MENU
key twice.
(6) Use the and keys to move the blinking cursor to “I/O” and press ENTER .
* The PNC-1850/1200 is equipped with an auto-interface function, and so
when left set to “AUTO,” it will automatically determine whether a parallel or
serial connection is used. When a serial connection is used, however, it is
necessary to set the communication parameters to match those set for the
computer (and/or software).
(7) Pressing the or key will sequentially display “PARA,” “SERI,” and
“AUTO.”
If you are using a parallel connection, display “PARA” or “AUTO” and press
ENTER .
If a serial connection is used, display “SERI” or “AUTO” and press ENTER . Then
set the communication parameters for the PNC-1850/1200 to match those selected
for the computer (and/or software).
(8) When “SERIAL” or “AUTO” is selected, the menu at right then appears on the
display. Set each parameter to match the parameters used by the computer or
software. (Refer to “Setting the protocol for a Serial connection” on page 28.)
* If the communication parameters for the computer and the PNC-1850/1200
are not identical, the cutting data cannot be received correctly, which may
result in faulty operation.
1-4-4 Selecting the Interface
Use the control panel to select the type of interface.
The selected interface type and communication parameters are stored in memory even after the power is switched off.
To change the interface type or the communication parameters, configurations must be re-entered.