2.3.3 Login Instructions/Example of Command Input
Before Logging In
Connecting to the AR-3000SD via Telnet requires that the IP address be set and other settings for the
AR-3000SD be made.
Note:
Changes in the IP address are reflected the next time the AR-3000SD's power is turned
on. For this reason, even though the IP address has been changed, the IP address
shown in the LCD screen will differ from the actual address until the power is turned off,
then on again.
Here is a case outlining logging in and entering commands, with an example of logging on using Telnet
from a command prompt connection with the conditions shown below.
For more detailed information about the actual commands, refer to Section 3 on.
1) When using Windows, select [Start]-[Run]; a text box opens.
(a) Enter the Telnet IP address.
When the AR-3000SD's IP address is 192.168.10.2
Telnet 192.168.10.2
2) Start up the Telnet software included with Windows.
(a) The login screen appears.
(b) If a password has been set, the “password:” prompt appears at login.
(c) After entering the password, the “AR>” prompt appears in the display.
Enter the “pl” command to play back Phrase #1. If there is a Phrase #1, then playback begins
and OK appears in the screen.
(d) Enter the exit command to end the session.
- When entering text, you can use the Backspace key to delete the immediately preceding
character.
- Both uppercase and lowercase alphabetical characters may be used in commands.
AR-3000SD (Ver.1.00) Command Reference - 14
