Rohm DURO-A, Перевод оригинального руководства по эксплуатации

Страница: 31 / 52

Assembly | 5
Power Chuck DURO-A 31 / 52
For sizes 110-210
1. Move the draw tube into the front position.
2. Move the piston (3) of the power chuck into the front position (jaws in
"open" position).
3. Undo the screw plugs (17) on the front of the power chuck and remove.
17
4. Press the chuck holding screws (10) inwards as far as they will go.
10
5. Screw the eyebolt into the power chuck (only for size 210).
6. Correctly attach the load-bearing equipment to the eyebolt (only for size
210).
7. Position the power chuck on the machine spindle.
8. Screw the power chuck onto the draw tube as far as it will go.
Ø Ensure that the draw tube thread is flush.
9. Turn back the power chuck until the drill holes of the machine spindle
head are flush with the chuck holding screws (10).
10. Power chuck must be pressed against the spindle holder and screwed
onto the machine spindle alternately with the three chuck fixing screws
(10) (provisionally 5 Nm).
11. Remove the load-bearing equipment from the eyebolt and the eyebolt
from the power chuck (only for size 210).