Rohde & Schwarz TSME, Руководство пользователя

Страница: 65 / 75

Troubleshooting
R&S
®
TSME
63 User Manual 1514.6542.02 ─ 10
Currently the R&S TSME does not answer to ICMP echo requests (PING). How-
ever, for ViCom users, a R&S TSME Ping tool is available after installation of R&S
ViCom (
C:\RuS\ViCom_15.0\tools\TSME\TsmePing.exe
).
●
Is the PC configured to use the subnet
192.168.0.0
with a different IP address to
the R&S TSME (default:
192.168.0.2
)? (See also Chapter 2.2.2.1, "Configuring
the LAN Interface on the Host PC" , on page 19.)
●
Are other applications trying to access the R&S TSME at the same time (e.g.
R&S ROMES, R&S NESTOR, R&S ViCom, R&S TSME Device Manager)? Check
the Windows TaskManager and look for associated processes. If necessary, stop
the processes.
●
Is the host using other network connections at the same time, such as VPN?
R&S TSME does not work when the PC is connected to VPN.
●
Is the connecting cable between the host and the R&S TSME the one provided
with the R&S TSME? Make sure you are using a quality CAT5e or better Gigabit
Ethernet conform cable. RJ45 connectors must be shielded, not plastic.
●
After switching the R&S TSME off and back on, is the [power] LED on the
R&S TSME blinking while the [state] LED is off ? This indicates that the TSME
cannot boot. Contact Rohde & Schwarz Support Center.
6.3 Solving Other Miscellaneous Problems
In case measurement problems occur with the R&S TSME, check the "Device Analysis
Output" table in the R&S TSME Device Manager for any errors that may have been
detected as a first measure (see Chapter 4.1, "The R&S TSME Device Manager" ,
on page 41).
Problem: R&S ROMES does not detect the R&S TSME .............................................. 63
Problem: The R&S TSME Device Manager does not detect the R&S TSME ............... 63
Problem: The options in the R&S TSME Device Manager are lost ...............................64
Problem: MIMO operation on multiple R&S TSMEs fails .............................................. 64
Problem: Error message: "No calibration data" .............................................................64
Problem: R&S TSME does not provide measurement data ..........................................64
Problem: The [STATE] LED is blinking red ....................................................................64
Problem: Instrument shuts down at lower temperature than expected ......................... 64
Problem: R&S ROMES does not detect the R&S TSME
Possible solutions:
●
Restart R&S ROMES, while the R&S TSME is connected and switched on.
●
Restart the PC and then start R&S ROMES, while the R&S TSME is connected
and switched on.
If you switch the instruments off and on again, be sure to switch on the R&S TSME
before you start R&S ROMES!
Problem: The R&S TSME Device Manager does not detect the R&S TSME
Solution:
Solving Other Miscellaneous Problems