Rohde & Schwarz TSME, Руководство пользователя

Страница: 18 / 75

Preparing for Use
R&S
®
TSME
16 User Manual 1514.6542.02 ─ 10
Figure 2-4: Supplied power cable with cigarette lighter adapter
Danger of shock!
To avoid a shock hazard and instrument damage, note the following:
●
After moisture condensation, allow the instrument to dry before switching on.
●
The instrument is still power-supplied while it is in standby mode, that is, with the
power button switched off, but still connected with the DC power supply.
●
After connecting the power supply the instrument is immediately under power.
●
The supplied DC connector is intended for disconnection.
●
If any DC supply other than R&S TSME-Z1 is used:
– The DC supply must be in accordance with IEC / EN / UL / CSA 60950-1 or
IEC / EN / UL / CSA EN EN61010-1.
– Use only Safety Extra Low Voltage (SELV) power supplies
– Observe the DC input range of 10 V to 27 V with maximum of 1.8 A (inrush cur-
rent)
– The 12 V vehicle cigarette lighter socket must be fused
2.2.2 Setting Up the LAN Connection to the Host PC
As mentioned in Chapter 1.2, "Measurement Setup" , on page 5, a host PC or notebook
with LAN interface is required to control and perform measurements with the
R&S
TSME.
Connecting the R&S TSME