Rohde & Schwarz TSME, Руководство пользователя

Страница: 52 / 75

Basic R&S TSME Functions
R&S
®
TSME
50 User Manual 1514.6542.02 ─ 10
When updating the correction data, you are asked to select a directory to store a
backup of your current correction data.
4.6 Configuring Measurement Bands
Depending on which options are installed, various different bands and technologies
can be scanned by the R&S
TSME.
Before you can configure the measurement bands you must install all required soft-
ware license keys, see
Chapter 4.4, "Installing and Managing Software License Keys" ,
on page 46.
The band configuration is stored on the R&S TSME and does not have to be per-
formed every time you switch on the device.
When using a R&S TSME with a limited number of measurement bands (see Chap-
ter 1.3.2, "Band Options" , on page 9), you must consider the band configuration of the
scanner when planning a measurement task. The scanner will only provide measure-
ment results for those bands that are currently configured on the scanner.
Example:
A R&S TSME is configured with band option TSME-K2B (2 bands measured simulta-
neously). During the last measurement, the R&S TSME was used to perform measure-
ments in 900 MHz and 1800 MHz bands. For the next measurement, the R&S TSME
can still only be used in 900 MHz and 1800 MHz bands, unless you change the band
configuration using the R&S
TSME Device Manager.
The band configuration is defined in the "Band Configuration" tab of the R&S TSME
Device Manager. Select the bands that are to be scanned by the R&S TSME in the
"Band Table". Which bands are available is independent of the installed technology
options; all installed technologies can be scanned in all configured bands at the same
time. The
number of bands available for selection depends on the installed band
options (see Chapter 1.3.2, "Band Options" , on page 9).
Configuring Measurement Bands