Rohde & Schwarz TSME, Руководство пользователя

Страница: 31 / 75

Preparing for Use
R&S
®
TSME
29 User Manual 1514.6542.02 ─ 10
This allows for optimum data rates since each scanner can use the full Gbit LAN
bandwidth to the host PC
●
Using a switch
This allows for simple connection and less wiring
Using separate network interface connectors (NICs)
The following graphic illustrates the setup for two R&S TSMEs connected to the same
host PC in parallel, using a dual NIC adapter on the PC and a synchronization cable
between the R&S
TSMEs (AUX ports).
The optional USB 3.0 To Gbit LAN Adapter R&S TSPC-U2L provides an additional port
on the host PC.
Figure 2-7: Configuration for parallel R&S TSME usage using separate network interface connectors
Each pair of R&S TSME and network interface connector is configured to be in a sepa-
rate subnet.
To configure two R&S TSMEs connected to one host PC using different NICs
1. To configure the network settings for both R&S TSMEs, set up the first LAN inter-
face on the PC to use the following network settings, as described in Chap-
ter 2.2.2.1, "Configuring the LAN Interface on the Host PC" , on page 19:
● IP address : 192.168.0.1
● Subnet mask : 255.255.255.0
2. Change the IP addresses of the R&S TSMEs so they are located in different sub-
nets, as described in Chapter 4.3, "Changing the IP Address for Multiple
R&S TSME Configuration" , on page 45.
a) Start the R&S TSME Device Manager.
b) Connect the first R&S TSME to the PC.
c) Define the IP address: 192.168.0.2 (default).
d) Connect the second R&S TSME to the PC.
e) Define the IP address: 192.168.1.2 .
Connecting the R&S TSME