Rohde & Schwarz R&S NRP-Z Series, Начало работы

Страница: 41 / 43

Operating Concepts
R&S
®
NRP-Zxx
33 Getting Started 1176.8822.02 ─ 03
Incorrectly connecting/disconnecting the R&S NRP
‑
Z power sensors may damage the
power sensors or lead to erroneous results.
Ensure that you connect/disconnect your power sensors as described in
Chapter 4.4,
"Connecting the R&S NRP
‑
Z Power Sensors" , on page 12 and Chapter 4.5, "Discon-
necting the R&S NRP
‑
Z Power Sensors" , on page 14.
Starting a measurement
1. Connect the cables as shown in Figure 6-4 :
a) Connect the DUT to the RF OUT connector of the R&S SMF.
b) Connect the DUT to the RF connector of the power sensor.
c) Connect the power sensor to the SENSOR connector of the R&S
SMF.
2. On the R&S SMF, open the "NRP-Z Power Viewer" dialog.
The dialog shows the result (in dBm) and some additional parameters.
3. If necessary, perform further settings.
For a detailed description of how to measure in this setup, refer to the operating man-
ual your compatible Rohde & Schwarz instrument.
Compatible Instrument