Rohde & Schwarz R&S NRP-Z Series, Начало работы

Страница: 26 / 43

Connecting to a PC
R&S
®
NRP-Zxx
18 Getting Started 1176.8822.02 ─ 03
Incorrectly connecting/disconnecting the R&S NRP
‑
Z power sensors may damage the
power sensors or lead to erroneous results.
Ensure that you connect/disconnect your power sensors as described in
Chapter 4.4,
"Connecting the R&S NRP
‑
Z Power Sensors" , on page 12 and Chapter 4.5, "Discon-
necting the R&S NRP
‑
Z Power Sensors" , on page 14.
1. Connect the cables as shown in Figure 5-2 :
a) Connect the R&S NRP
‑
Z3 active USB adapter to the power sensor.
b) Connect the power sensor passive USB adapter to the computer.
c) Connect the power sensor to the signal source.
d) Connect the R&S NRP
‑
Z3 with a BNC cable to the trigger source (optional).
e) Connect the delivered plug-in power supply to the R&S NRP
‑
Z3 and to an AC
supply connector (optional).
2. On the PC, start a software application to view the measurement results. See
Chapter 6, "Operating Concepts" , on page 21.
5.3 Using an R&S NRP
‑
Z5 Sensor Hub
The R&S NRP
‑
Z5 sensor hub (high-speed USB 2.0) can host up to four R&S NRP
‑
Z
power sensors and provides simultaneous internal and external triggering of all con-
nected sensors.
Required equipment
●
R&S NRP
‑
Z power sensor
●
R&S NRP
‑
Z5 sensor hub that provides:
– Power supply
– Through-wired trigger bus
– Trigger input and trigger output via BNC sockets
●
PC with installed R&S NRP Toolkit, see Chapter 6.1, "R&S NRP Toolkit" ,
on page 21
Using an R&S NRP
‑
Z5 Sensor Hub