Rohde & Schwarz R&S NRP-Z Series, Начало работы

Страница: 22 / 43

Preparing for Use
R&S
®
NRP-Zxx
14 Getting Started 1176.8822.02 ─ 03
4.5 Disconnecting the R&S NRP
‑
Z Power Sensors
Additional requirements must be fulfilled when disconnecting the R&S NRP-Z27/-Z28/-
Z37/-Z98 sensors. Refer to the operating manual of the corresponding sensor for a
description on how to disconnect it.
4.5.1 Disconnecting the RF Connector of the R&S NRP
‑
Z Power Sensors
Risk of damage to the center pin of the RF connector
When disconnecting the power sensor, always rotate only the union nut of the RF con-
nector. Do not rotate the sensor itself to avoid damage the center pin of the connector.
► Carefully loosen the screw at the front of the sensor's RF connector and remove
the sensor.
4.5.2 Disconnecting the Host Connector of the R&S NRP
‑
Z Power Sen-
sors
To disconnect from an R&S NRP
‑
Z3 or R&S NRP
‑
Z4 adapter
► Pull at the host connector ( Figure 4-2 (
3
) ) until it disconnects from the connector of
the USB adapter.
To disconnect from an Rohde & Schwarz instrument or an R&S NRP
‑
Z5 sensor
hub
► At the same time, press down the ring of the built-in plug (
1
) and pull off the cable
sleeve (
2
).
Disconnecting the R&S NRP
‑
Z Power Sensors