Preparing for Use
R&S
®
NRP-Zxx
13
Getting Started 1176.8822.02 ─ 03
3. To ensure a maximal measurement accuracy, tighten the RF connector using a tor-
que wrench with the recommended nominal torque (see the operating manual of
your power sensor).
4.4.2 Connecting the Host Connector of the R&S NRP
‑
Z Power Sensors
To connect to an adapter
You can use an R&S NRP
‑
Z3 or R&S NRP
‑
Z4 adapter.
1. Rotate both cables, so that the red markings on the sleeves of both of them are at
the same position.
2. Insert the host connector of your sensor into the connector of your USB adapter.
Figure 4-2: Connecting the host connector
1 = R&S NRP
‑
Z4 in this example
2 = Red marking
3 = Host connector
4 = R&S NRP
‑
Z power sensor
To connect to an R&S NRP
‑
Z5 sensor hub
► Insert the host connector, red marking upwards, into the SENSOR connector of
your sensor hub.
To connect to an Rohde & Schwarz instrument
► Insert the host connector, red marking upwards, into the SENSOR connector of
your instrument.
Connecting the R&S NRP
‑
Z Power Sensors
