Connecting to a PC
R&S
®
NRP-Zxx
20
Getting Started 1176.8822.02 ─ 03
Incorrectly connecting/disconnecting the R&S NRP
‑
Z power sensors may damage the
power sensors or lead to erroneous results.
Ensure that you connect/disconnect your power sensors as described in
1. Connect the cables as shown in
a) Connect the power sensors to the R&S NRP
‑
Z5 sensor hub. You can connect
up to four sensors.
b) Connect the R&S NRP
‑
Z5 to the computer.
c) Connect the power sensors to the signal source.
d) Connect the delivered external power supply unit to the R&S NRP
‑
Z5 and to an
AC supply connector.
e) Connect the R&S NRP
‑
Z5 with a BNC cable to the trigger source (optional).
f) Connect the R&S NRP
‑
Z5 with a BNC cable to the trigger device (optional).
2. On the PC, start a software application to view the measurement results. See
Chapter 6, "Operating Concepts"
Using an R&S NRP
‑
Z5 Sensor Hub
