Rohde & Schwarz NRPM OTA Power Measurement Solution, Руководство пользователя

Страница: 80 / 229

Performing measurements
R&S
®
NRPM
80 Mannual 1425.8663.02 ─ 08
Access:
► In the settings navigation pane of the web browser-based user interface,
select "System".
The remote commands required to define the system settings are described in
Chapter 10.4.1, "Configuring the system" , on page 120.
IP Address ............................................................................................................ 80
Subnet Mask .........................................................................................................80
Gateway ................................................................................................................80
DHCP ....................................................................................................................81
Apply Network Settings .........................................................................................81
Sensor Name ........................................................................................................81
Update .................................................................................................................. 81
Selftest ..................................................................................................................81
IP Address
Sets the IP address of the sensor module.
Remote command:
SYSTem:COMMunicate:NETWork:IPADdress
on page 121
Subnet Mask
Sets the subnet mask.
The subnet mask consists of four number blocks separated by dots. Every block
contains 3 digits at a maximum.
Remote command:
SYSTem:COMMunicate:NETWork:IPADdress:SUBNet:MASK
on page 122
Gateway
Sets the address of the default gateway that means the router that is used to for-
ward traffic to destinations beyond the local network. This router is on the same
network as the instrument.
Remote command:
SYSTem:COMMunicate:NETWork:IPADdress:GATeway
on page 121
Measurement applications