Rohde & Schwarz 2112.4100.02, Начало работы

Страница: 70 / 79

Installed Software
R&S
®
SFE100
51 Getting Started 2112.4122.62 ─ 13
10.3.2 Recommended Procedure for the R&S SFE100 Models 02, 03
This procedure is performed by using the hardkeys and display on the front panel that
are only provided by the models 02, 03. You do not need to connect an external moni-
tor.
To restore the factory system partition
1. Switch the R&S SFE100 off and on again.
While the boot screen is visible, the three LEDs on the front panel start blinking.
2. If a recovery is needed, press the BACK key within 4 seconds.
The following message is displayed: "Restore factory default? Press OK to start
restore."
3. Within the next 4 seconds, press OK. Otherwise the restore is skipped and the reg-
ular boot process continues.
After pressing OK within 4 seconds, the recovery process starts and the following
message is displayed: "Restore in progress! Please wait..."
After the restore process is finished, a "warm boot" is carried out and R&S
SFE100
continues with normal operation.
10.3.3 Windows XP Embedded Recovery and Backup Partition Dialog
Recommended procedure for the R&S SFE100 models 12, 13.
To display the Windows XP Embedded Recovery and Backup Partition dialog
1. Connect an external monitor, a keyboard and a mouse ( Chapter 6.3, "Connecting
External Devices" , on page 29).
2. Switch the R&S SFE100 off and on again.
The boot screen is displayed with the default selection "Firmware". If you do not
perform step
step 3 within 4 seconds, the dialog vanishes and the booting process
continues.
3. Select "Backup/Recovery" and press ENTER.
Windows XP Recovery and Backup Partition