PR311-BK fv102 Rev B. ENG.doc.DOC
8/9/2006
_________________________________________________________________________________________
_________________________________________________________________________________________
Page
14
4.12.
Option: Controller Timed Lock-out
If the controller recognizes three consecutive attempts of entry of a non-valid
identifier it will ignore all attempts to enter any identifier within next three minutes.
During this three minutes of penalty time controller will continue its operation with
all other functionalities.
Note: Every use of authorized identifier clear counter for this option.
4.13.
System Flags
System Flags
are the logical registers which exist in controller’s memory. Each flag
represent a status of relevant situation which may occur on a controller and have a
set of cause which may set or clear it. Every
System Flag
has assigned a separate
Timer
. The
Timer
specifies for what time the relevant
System Flag
will remain
active after it is set ON. The
Timers
for AUX1 and LIGHT flags can be optionally
programmed for unlimited time (
Latch
mode) in this case once the
System Flag
is
set it will remain ON till the moment when adequate command or adequate event
will clear it. The condition of each
Flag
can be signaled on the output line.
The PR311-BK utilizes the following
System Flags
:
•
AUX1
•
LIGHT
•
TAMPER
•
DURESS
Table 2. System Flags in the PR311-BK.
Flag
Latch
Mode
Setting methods
Clearing methods
AUX1
YES
1.
Programming Card
(PC-F12).
2.
Programming Card
(PC-F14).
3.
Input line (Function no. 71).
4.
Input line (Function no. 73).
1.
Programming Card
(PC-F13).
2.
Programming Card
(PC-F14).
3.
Input line (Function no. 72).
4.
Input line (Function no. 73).
5.
Controller restart.
LIGHT
YES
1.
Programming Card
(PC-F15).
2.
Programming Card
(PC- F17).
3.
Input line (Function no. 68).
4.
Input line (Function no. 70).
5.
[F2] function key.
1.
Programming Card
(PC-F16).
2.
Programming Card
(PC- F17).
3.
Input line (Function no. 69).
4.
Input line (Function no. 70).
5.
[F2] function key.
6.
Controller restart.
TAMPER
NO
1.
Input line (Function no. 8).
1.
Arm/Disarm
of the controller.
2.
Controller restart.
