
RODIA
®
130/164/300
GB
23
Switching On/Off
Switching on:
Press the ON/OFF switch
2
(position “1”).
Switching off:
Press the ON/OFF switch
2
(position “0”).
WARNING: Use Rodia 130-H/-P
only in combination with a drillstand
when drilling in first gear, Position 1
(low speed).
Overload Protection
The LED
1
indicates the motor load, whereby
the following conditions are distinguished:
Blue:
No load
Green: Regular drilling load
Red:
Overload
Excessive overloading the motor will reduce
the speed 6 times electronically to warn the
operator. The motor switches off automatically
and can immediately be switched back on
again.
Connecting the water feed
•
Close the water tap
7
.
•
Connect the water feed hose to the water
tap or the water pressure tank.
•
When using the water pressure tank, make
sure that there is sufficient pressure when
working.
•
Check the waterflow indicator
3
.
Mounting the drill bit 31
•
Clean and grease the thread on the drill
bit
31
and the tool holding fixture
6
.
•
Screw a core bit
31
onto the tool holder
6
and tighten.
Removing the drilling core
•
Break off the drilling core and remove.
hANd heLd dRILLING
WARNING: Hand held drilling only
for Rodia 130-H/-P. Maximum bit
diameters:
•
Wet drilling in concrete: Ø 40
mm.
•
Dry drilling in masonry: Ø 164
mm.
Hand held wet drilling
•
For wet drilling open the water valve
7
and switch on the machine
2
.
•
Hold the machine as rigidly as possible.
•
Always use the grip
5
at the front of the
machine.
•
Start drilling by keeping the machine at a
slight angle.
•
After the bit is guiding itself into the mate-
rial, swivel back the machine into the right
angle position.
Hand held dry drilling
Mounting the dry drilling kit 10
A
B
•
Loosen the frontgrip
5
of the core drilling
machine.
•
Mount part A of the dry drilling kit onto the
drill spindle
6
.
•
Slide the dry drilling sleeve (B) on part
A in the desired position for the vacuum
cleaner.
•
Tighten the grip
5
.
•
Mount the hose of a industrial vacuum
cleaner on the sleeve (B).
•
Mount a core drill
31
onto the drill spindle
6
.
Using the dry drilling kit 10
•
Drilling is only possible if the masonry is
absolutley dry. Use a powerful industrial
dust exhauster. Change the filter regularly,
there is risk of obstruction.