RODIA
®
130/164/300
GB
20
FoR youR sAFety
Working safely with this machine is
possible only when the operating
and safety information are read
completely and the instructions con-
tained therein are strictly followed.
Before using for the first time, ask for
a practical demonstration.
Before working on the machine itself,
pull the mains plug.
•
Be careful of hidden electrical lines or gas
and water pipes. Check the working area,
e. g., with a metal detector.
•
Before commencing work consult the
responsible structural engineers, architects
or site supervision about any planned
borings, especially when cutting through
reinforcing steel.
•
Never use the machine without the PRCD
(GFCI) provided with the machine.
•
Always test the PRCD (GFCI) before start-
ing work, unless the PRCD (GFCI) is a
selftesting type.
•
The machine may only be operated using
a power supply with protection earthing
according to the regulations.
•
Never use the tool without the separating
transformer delivered with the tool or of the
type as specified in these instructions.
•
Replacement of the power cord or plug
should always be carried out by the manu-
facturer or a qualified service facility.
•
Keep liquid clear of parts of the tool and
away from persons in the working area.
•
The machine may not be operated by per-
sons under the age of 16 years.
•
The drill stand must always be mounted
firmly and must not be able to move during
drilling.
•
Only mount the drill stand on an even,
firm and smooth surface using the vacuum
pump.
•
When carrying out “over” head wet cut
core drilling, a water collecting ring and
water suction are always to be used.
These must be in perfect condition.
•
When drilling “over” head
always
secure the drill stand with the assembly.
•
Prevent the drilling core from falling.
Vacuum pump
•
Avoid any constrictions in the suction hose,
e.g. due to dirt accumulation, squeezing,
bending or stretching.
•
Check the suction hose each time before
use. Renew any leaking or damaged
parts.
•
Keep the cooling air vents on the pump
free and clean.
•
The underlying surface of the drill stand
must be clean, firm, smooth, dry and
without any holes. For further safety regula-
tions, see the operating instructions for the
drill stand.
•
Caution: The machine automatically
switches on immediately after inserting the
plug in the mains and becomes hot after a
long period of use.
•
Always
connect the core drill and the
vacuum pump to the same power outlet.
•
Do not carry out any changes or modifica-
tions to the machine.
•
Should the machine have an operational
fault, the vacuum function will remain for a
short time. The cohesion is depe dent upon
the underlying surface and seal retention.
Stop working immediately and remove the
drill stand completely.
Use only original Rodia parts and
accessories.