Rockwell Automation Allen-Bradley LDAT-S03 Series, Руководство пользователя

Страница: 24 / 76

24 Rockwell Automation Publication LDAT-UM001A-EN-P - April 2016
Chapter 2 Installation
Be sure the work load center of gravity is centric to the slider
Use these torque values to attach a rod eye, rod clevis or payload bracket
to the slider.
If your installation includes a counter-balance kit, install counter-
balance end bracket between slider end cap and slider-end accessory.
Complete counter-balance kit installation by following steps in
Install
Counterbalance Kit on page 24 .
Install Counterbalance Kit
Follow these steps to install the counter-balance kit.
Unless otherwise noted, torque specifications have a ±20% tolerance.
1. Remove M8 set screws from stator body.
2. Install stator bracket with two M8 x 1.25 x 16 socket head cap screws
(SHCS).
Torque screw to 19.2 N•m (14.2 lb•ft).
3. Screw one 3/8 in. hex nut onto a spring anchor.
4. Install hex nut and spring anchor assemble in one of the three threaded
mount locations.
ATTENTION: Damage can occur to the linear thruster bearings and the
feedback device if the slider receives a sharp impact during installation. Do
not strike the slider with tools during installation or removal.
Failure to observe these safety precautions could result in damage to the
linear thruster and its components.
Cat. No. Torque, max
(1)
(1) Unless otherwise noted, torque specifications have a ±20% tolerance.
LDAT-S03 6.8 N•m (5 lb•ft)
LDAT-S05
LDAT-S07
LDAT-S10 14.7 N•m (10.83 lb•ft)
LDAT-S15