Publication CNET-IN002A-EN-P - December 2001
Install a ControlNet Coax Media System
3-7
Locally Available Tools
You will also need these local-purchase tools (not supplied in the kit):
•
3/32” Allen wrench
•
heat gun (if you are installing IP65 or IP67 corrosion-resistant
connectors)
Calibrate the Cutting
Blades
Use the following procedure to calibrate your cable strip tool to cut
FEP or PVC cable.
1.
Turn the three screws outward to back the blades out. This
prevents the calibration tool from bottoming out.
2.
Place the calibration tool into the cable strip tool with the
narrow end installed and facing forward for FEP cable (use the
wider end for PVC).
3.
Tighten the chamber gauge ring so that the calibration tool is
locked in place. Close all the way to the chamber gauge stop.
ATTENTION
!
Be certain to perform the calibration procedure the
first time you use the tool and every time you change
the blade for both memory cartridges. Due to slight
differences between Coax cables, calibration should
be performed when changing:
•
part numbers
•
from one cable manufacturer to another
2088-m
adjusting screws
To:
Turn the screw:
increase the cut depth
clockwise
decrease the cut depth
counterclockwise
41892
FEP
PVC
calibration tool
IMPORTANT
When aligned properly, the grooves of the
calibration tool should align with the blades.
Содержание Allen-Bradley ControlNet 1786 Series
