Rockwell Automation Allen-Bradley ControlNet 1786 Series, Руководство по установке

Страница: 47 / 74

Publication CNET-IN002A-EN-P - December 2001
Install a ControlNet Coax Media System 3-11
5. Holding the cable in one hand, place the index finger of your
other hand inside the chamber-gauge ring and turn the strip tool
360° around the cable. Turn four or five full rotations until the
strip tool glides easily around the cable.
6. After you have moved the chamber gauge ring to the last
position and turned the strip tool the final time:
a. Move the chamber gauge ring backward to release the strip
tool and remove it from the cable.
b. If you are using Allen-Bradley IP65 and IP67
corrosion-resistant connectors, slide the heat shrink tubing
over the cable.
c. Slip the crimp ferrule onto the cable. Push it back to the
sheath area of the cable to keep it out of the way for the
moment.
d. Strip away the appropriate portion of the cable without using
the strip tool.
IMPORTANT
On your last repetition of steps 4 and 5, apply
sufficient pressure on the chamber gauge ring to
make sure the ring has reached the last stage. The
chamber gauge should read ‘stop’ for the last
repetition.
Repeat steps 4 and 5, moving the chamber gauge ring
forward one notch for each time you repeat the steps,
until you reach the last notch.
Each time you move the chamber gauge ring forward a
notch, the strip tool makes a deeper cut into the cable.
20074
crimp ferrule
cable
41887a