Rockwell Automation Allen-Bradley ControlNet 1786 Series, Руководство по установке

Страница: 44 / 74

Publication CNET-IN002A-EN-P - December 2001
3-8 Install a ControlNet Coax Media System
4. Adjust the screws of the memory clip so that the blades just
touch the calibration tool.
5. Retract the handle of the cable strip tool.
6. Remove the calibration tool from the cable strip tool.
When you are finished, the blade should make a cut of the following
dimensions in your cable.
ATTENTION
!
Do not over-tighten the screws of the cable strip
tool. The blades should not bend, shift, or penetrate
the calibration tool.
First Cut: all four shield
layers-braid/tape/braid/tape
Second Cut: white
insulation or 1st tape
Third Cut: center conductor
The first cut should cut the
outer sheath without cutting
the outer wire braid. If the
braid is frayed, scored, or cut
by the blade, adjust the blade
outward slightly to eliminate
the fraying.
The second cut should cut the
sheath, three outer shields, and
possibly the inner tape shield. The
insulation can be scored slightly,
but should not have a deep cut.
The third cut should cut all layers
of the cable down to the center
conductor. This cut should not
score the center conductor. If the
blade leaves a mark on the
conductor, adjust the blade slightly
so to eliminate marking the
conductor.
8.3 mm
3.7
4.0
30030-m
PVC CL2
IMPORTANT
The first and second cut adjustments need to be
precise. Adjustments as small as 1/12 to 1/8 of a turn
can make the difference between a perfect and an
imperfect cut.