Rockwell Automation Publication 750-IN118A-EN-P - May 2021
79
Chapter 3 Mechanical and Electrical Installation
Figure 73 - Frame 9 Configured Input Bay with Circuit Breaker, Top
Entry: Internal Components and Installation Connection Locations
Item Description
1
Three-front-vents exhaust hood with internal air filters
2
PE ground bar with ground clamps included. Terminating point to
chassis ground for incoming AC line and shield. Ground connections
must be made during installation.
3
Thermostat
4
Control relay
5
Control terminal blocks
6
Fuse blocks
7
Control power supply (24V DC)
8
Uninterruptible power supply (behind control power supply)
9
Battery
10
Control transformer
11
PE ground bar
12
PE ground bar splice connection hardware. Ground splice connection to
drive PE ground bar must be made during installation.
13
Cable support brackets - support and guide power cables that connect
to the drive input bay
14
Terminal lugs to supply power to the drive input bay. Cables are
connected to these terminals at the factory. Cables must be connected
to the drive during installation.
15
AC line input protection circuit breaker
16
Terminal lugs for customer AC line input power. Connections must be
made during installation.
17
Configured bay control connectors for control connections to
configured output bay (not visible in this view, located behind bay
frame). Connections must be made during installation.
2
4
5
6
7
1
8
9
3
15
17
14
16
13
12
10
11
