26
Rockwell Automation Publication 750-IN118A-EN-P - May 2021
Chapter 1 Product Overview
Commonly Used Installation
Tools
This section provides information about tools that are used to install and
configure
PowerFlex 755T Drives Configured to Order Program products.
Installation Tools
This list includes the tools that are needed for installation and test
measurements.
IMPORTANT
Make sure that tools and/or hardware components do not fall into open
drive assemblies. Do not energize the product unless all loose tools
and/or hardware components have been removed from the bays.
Tool Description
Details
Allen socket wrench
4 mm, 5 mm (with long extension)
Allen socket wrench extension 254 mm (10 in.)
Box wrench
7 mm, 8 mm, 10 mm, 13 mm, 17 mm, 19 mm, 22 mm
Ratcheting wrench
17 mm
Crimping tools
For cable terminals 1.5...240
Current clamp
1000 A (AC, rms), signal output
ESD-protected place of work
Work surface, floor cover, seat, and ground connections
ESD-protective clothing
Wrist wrap, shoes, overall clothing (coat)
Flashlight
—
Flat-nose screwdriver
3 mm (0.12 in.), 5 mm (0.19 in.), 6.4 mm (0.25 in.)
Fuse puller
—
Hexalobular (star or Torx)
screw driver/bit
#15, #20, #25, #30, #40, #45
Hexagonal socket wrench
2.5 mm, 7 mm, 8 mm, 10 mm, 12 mm, 13 mm, 17 mm, 18 mm
Insulation tester
1000V DC
DCPC module lift
Used together with the module service cart to remove DC precharge
modules.
Module storage hardware
Module storage hardware (20-750-MINV-ATIP) helps to stabilize power
and filter modules during temporary storage after removal.
Multi-meter
Digital multi-meter, capable of AC and DC voltage, continuity,
resistance, capacitance measurements, and forward diode bias tests.
Fluke model 87 III or equivalent.
Nose pliers
—
Oscilloscope
Portable, digitizing, dual channel scope, with isolation
Phillips screwdriver/bit
#1, #2
Torque wrench
1...12 N
•
m (8.8…106 lb
•
in)
Torque wrench
6...50 N
•
m (53…443 lb
•
in)
Wire cutter
—
