28
If the appliance has to be lifted, pass slings into the openings in the base supports and
use spreader bars to prevent the slings from damaging the casing during handling (see
Figure 5.1 Instruction for lifting
→
28).
The lifting crane and all accessory devices (braces, cables, bars) must be suitable sized for
the load to be lifted. For the weight of the appliance, consult Table 3.1 GAHP-A LT techni-
cal data
→
11 or Table 3.2 GAHP-A HT technical data
→
13.
the manufacturer cannot be held responsible for any damage occurring during the
installation of the appliance�
figure 5�1 – Instruction for lifting
The appliance can be installed at ground level, on a terrace or on a roof (if compatible
with its “dimensions” and “weight”).
The dimensions and weight of the appliance are given in Table 3.1 GAHP-A LT technical
data
→
11 or Table 3.2 GAHP-A HT technical data
→
13.
MoUntInG BAse
Always place the appliance on a levelled flat surface made of fireproof material and able
to support the weight of the appliance.
In addition, provide a small “containing” step that will prevent water from spreading dur-
ing possible winter defrosting phases.
During winter operation, the appliance (depending on temperature and humidity condi-
tions of the outdoor air) can carry out defrosting cycles melting the layer of frost/ice on
the coil.
Take this possibility into consideration, adopting appropriate measures (for example:
a“containing” step and channelling of water into a suitable drain) in order to prevent "un-
