Installation, user and maintenance manual
– GAHP-A
37
figure 5�4 – Fume outlet
LeGend
A
Curve 90° Ø 80
B
Pipe Ø 80 Lg.300 mm w/terminal
C
rain cover
A
B
C
5�8
PRoGRAMMInG of HYdRAULIC PARAMeteRs
The operations described in this paragraph are necessary only if the appliance is not con-
nected to a DDC or to a CCP.
If the appliance is connected to a CCP/DDC, follow the instructions given in the CCP/DDC
manuals exclusively.
This paragraph explains how to set the hydraulic parameters on the electronic board
of the appliance. Users not familiar with the basic procedures for the use of the board
should refer to Paragraph 4.2 ON-BOARD ELECTRONICS
→
19.
To configure the appliance, access menu 3 of the electronic board.
With regard to the hydraulic configuration, three parameters may be set: select the letter
E to exit to the previous menu.
table 5�4 – Menu 3 parameters
HYdRAULIC PARAMeteR
tHe dIsPLAY sHoWs
Hot water thermostat control selection
3.160
Hot water setpoint
3.161
Hot water temperature differential
3.162
(EXIT MENU)
3. E
description of parameters: