Robopac ROBOT S7, Руководство по эксплуатации и обслуживанию

Страница: 82 / 92

82
MAINTENANCE INFORMATION ENG
7. MAINTENANCE INFORMATION
7.1. RECOMMENDATIONS FOR MAINTENANCE
- Stop the machine (as indicated in paragraph “machine safe stop”).
- Proper maintenance will allow a longer life span and constant compliance with safety requirements.
- Before performing any operation, the authorised operator must make sure to have understood the “Instructions
for use”.
- Pay attention to the safety warnings, do not misuse the machine and assess the possible residual risks.
- Carry out the interventions with all the safety devices enabled and wear the required PPE.
- Indicate the intervention areas and prevent access to the devices that, if activated, could cause unexpected
hazards and compromise safety.
- Do not carry out interventions that are not described in the manual but contact an service centre authorised by
the Manufacturer.
- Do not dispose of materials, polluting liquids and the waste generated during the interventions into the
environment but dispose of them according to the standards in force.
7.2. PERIODICAL MAINTENANCE INTERVALS
The table indicates the scheduled maintenance intervals which allow to obtain best performance, long operating life and
a constant level of safety.
Maintenance interval table
Frequency Component Type of intervention Intervention mode Reference
Every 40 hours or
1000 cycles (*)
Machine working
areas
Clean Use a cloth or air jet -
Every 200 hours or
5000 cycles (*)
Rubber rollers Clean Use a cloth soaked in
alcohol
-
Every 200 hours or
5000 cycles (*)
Film carriage Lubricate - See “Lubrication
point diagram”
Check the chain
tensioning
- See “Film carriage
lifting chain
adjustment”
Every 5000 hours
or 50000 cycles (*)
Reduction units
and gearmotors
Change the
lubricant¹
- See “Lubrication
point diagram”
Every 10000 hours
or 100000 cycles (*)
Steering return
spring
Replace
1
Do not top up and/or change in life-lubed reduction units and gearmotors.

Cycle timings have been defined on the basis of the standard cycle.
The standard cycle is the following: 500 mm high film reel, 1500 mm high pallet, pallet weight equal to 1500 kg,
total wrapping cycle consisting of two turns at the base, two turns at the top with rotation speed of 12 r.p.m. or
80 m/1’ and carriage upstroke and downstroke speed equal to 4 m/1’ .