Robopac ROBOT S7, Руководство по эксплуатации и обслуживанию

Страница: 75 / 92

ENG INFORMATION ABOUT THE USE
75
6.15. WRAPPING START AND STOP
Proceed as follows.
1. Press the button (A) to enable the power supply of controls.
The digital display (B) turns on.
2. Press the button (C) to reset the machine.
3. Use the buttons (D) to move the machine closer to the pallet, until the feeler wheel (E) leans against the pallet.
4. Check that the feeler wheel (E) is aligned with the pallet and not with the product.
Adjust the height of the feeler wheel.
(See “Adjusting the height of the feeler wheel”).
5. Let the film adhere to the pallet.
6. Set the wrapping mode.
For further details, see paragraph "Programming a new recipe".
7. Check that the parameters on the "Home" page are correct.
Caution - warning
Do not stretch or pre-stretch the film excessively and do not wrap the product with too many wrappings in
order to prevent damaging the packages and the products contained in them.
8. Press the "Cycle Start" button (F).
The machine performs the wrapping and, at the end of the set cycle, it stops automatically.
9. Cut the film (manual or automatic cutting).