Robland Z400 EL, Руководство пользователя

Страница: 26 / 72

26
V0119 Z400-serie
English Deutsch
Calibration of the scale on the parallel
fence
(Fig.23-25)
Each time a new sawblade is fitted the parallel fence scale has to be calibrated to the new sawblade.
By cutting a sample and measuring its exact length, the scale can be adjusted so that the exact
measure corresponds with the front side of the fence.
After the screw (1) has been loosened the scale can be adjusted. To avoid the fence contacting the
sawblade while it is revolving, the stop ring (2) has to be adjusted. Slide the fence to about 10 mm
from the sawblade. Now slide the stop ring (2) across the round guide bar (3) until it comes up against
the casting of the fence. Tighten the lock screw on the stop ring.
For a digital reading: Move the parallel fence against the saw blade, and then simultaneously press
the “F” and “SET” buttons. The value on the digital reading jumps to “0”.
Then shift the locking ring (fig. 25.3) onto the saw guide (2) until the cutting width is limited to 2 mm.
This prevents inadvertent contact with the saw blade.
If the size display is not correct when the digital display is read, check the distance between the
sensor (Fig. 23.2) and the digital measuring tape (Fig. 23.1). This may be max 0.2 mm. If necessary,
adjust this with the adjusting bolts (fig. 23.3).
Fig.23 Fig.25
Cutting with mitre fence
(Fig.24)
The nut for receiving the wood clamp shaft (1) is set from the factory and must not be moved. The set
angle can be read at the rear of the large angle bracket (4). The angle is changed by unloading the
shaft (1) and releasing the clamping lever (2). The stop profile (5) itself can be moved by releasing the
2 clamping levers (3).
Fig.24