Robland Z400 EL, Руководство пользователя

Страница: 30 / 72

30
V0119 Z400-serie
English Deutsch
Maintenance of the machine
All maintenance and cleaning work may only be carried out with the main switch set to “O”. The
machine must have been switched off from the mains.
In order to guarantee the life of your machine and also to optimize the quality of your delivered work,
we strongly recommend cleaning the machine once a week and remove all dust and chips that have
accumulated on different parts of the machine.
Especially the carriage must be well maintained. To do this, slide the trolley to the rear and carefully
blow all dust and dirt from between the two profiles and ball cage. Afterwards the steel carriages of
the car must be lubricated with a simple lubricant in spray such as WD40 or other means.
All ball bearings used in the machine are dust-tight and require no lubrication.
Remove any resin deposits on the machine and regularly lubricate the steel axle of the parallel fence.
Caution: when using solvents, be very careful about the risk of fire. !! Do not smoke and keep
the products away from heat sources !!
Problems: causes and solutions
1 The machine does not start when the start button is activated:
- access door is still open: close the door correctly
- main fuse is switched off: power cut, power shortage or motor overload
2 Reduction of speed when working:
- belt tension not correct: tension the belt
- motor overload due to incorrect feed rate: reduce the feed rate
- blunt tools: sharpen tools
3 Vibration of the sawblade or spindle:
- unbalanced tool: replace or have the tool balanced
- worn or damaged belt: replace the belt
4 Thermal overload does not re-arm automatically after shut-off and cooling down period:
- overload is not set on automatic reset or the overload is faulty
If you cannot solve the problem yourself or you do not find your problem in this list, please contact
your Robland dealer.