Robe ColorSpot 575E AT, Руководство пользователя

Страница: 9 / 39

9
4.5 Connection to the mains
Verify the power supply settings before applying power!
If you wish to change the power supply settings,see the chapter below.
Connect the fixture to the mains with the enclosed power plug.If you need to install other power plug on the power
cable,follow the identification table below.
The earth has to be connected!
Do not connect the fixture to a dimmer system!
The occupation of the connection-cables is as follows:
Cable (EU) Cable (US) Pin International
Brown Black Live L
Light blue White Neutral N
Yellow/Green Green Earth
4.6 Changing the power supply settings
Electronic ballast
The operating range of the electronic ballast is 90 VAC-250 VAC,50-60Hz.The transformer has to be set to the
local AC voltage.
If you want to change the power supply settings,follow the instructions:
1.Disconnect the fixture from AC power.
2.Remove the both top base covers by loosening the 12 screws.
3.Move the wire (3) on the transformer connection block to the position according to the desired voltage.
5.Close the base before applying AC power.
Example:
prism module
prism holder
pressing snap
fixative holes