Robe ColorSpot 575E AT, Руководство пользователя

Страница: 30 / 39

30
Fan Modes --- By using this function you can choose 2 types of the fan speed operating modes.
Auto Cooling --- The fans automatically raise their speed in order to control inside temperature
of the lighting, if the temperature inside increases about certain level (the low fan speed reduces the
cooling of the lighting). This cycle can repeat several times until the temperature inside is on a
suitable level.
High Cooling --- The cooling fans work on max. speed (max. cooling).This mode we recommend for
high ambient temperature (30 °C and more).
Pan/Tilt mode --- Use this menu to set the character of the pan/tilt movement.
Time mode --- Pan and tilt will move with different speeds and they will come at the same
time to end point (pan and tilt sets its optimal speed).
Speed Mode --- Pan and tilt will move with the same speed as adjusted by the channel 5
(Pan/Tilt speed).E.g. pan will come to the end point and wait for tilt,which has longer track.
Active Blackout while: --- Use this function if you wish to close the light output during effect changes.
Pan/Tilt Moving --- This function closes the light output during pan/tilt changes.
Colour Wheel Moving --- This function closes the light output during colour wheel 1/wheel 2
changes.
Gobo Wheels Moving --- This function closes the light output during statis gobo wheel /
rotating gobo wheel changes.
IR Sensor --- Select this function to switch on/off infra-red remote control .
Init Effect Positions --- Select this function to set all effects to the desired positions.After switching the fixture on
(if DMX is not connected),all effects will move to this init positions.
Note: If you operate e.g. 27 channels pre-setting (Mode 1) and you adjust DMX values for channels which are not
included in this mode,you will not be able to change these effects from the controller !
Default Settings --- Select this option to reset all fixture personalities to the default values.
9.4 Lamp On/Off
Use this option in order to switch on/off the lamp.It is also important to note, that the lamp is cold restrike type,
that means, that it has to be cold before striking.
9.5 Test sequences
Use this menu to to run a special demo-test sequences without an external controller, which will show you some
possibilities of using ColorSpot 575E AT.
Mode 1 --- This mode is suitable for projections on the wall, ceiling or ground without any head
movement.
Mode 2 --- This mode uses all ColorSpot 575E AT functions including pan/tilt movement and
therefore is good for a complete introduction of the fixture.
9.6 Manual mode
Presetted Effects --- Select this menu to call up presetted positions of channel effects.
Manual Effect control --- Select this menu to control channels by control elements on the control board.
9.7 Stand-alone setting
Use this menu to set options for stand-alone mode as a selection of the playing program,programming and
modifying current programs.
Music Trigger --- Select this function to enable the sound control of the running programs via the
built-in microphone.
Presetting Playback --- This function allows you to select the program which will be played in the
stand-alone mode after switching the fixture on.Selected program will be played
continuously in a loop.
Disabled --- The option disables "Presetting playback" function.
Test Program --- The option will start built-in test program.
Program 1 --- The option will start created program No.1
Program 2 --- The option will start created program No. 2