Robe ColorSpot 575E AT, Руководство пользователя

Страница: 32 / 39

32
Pan/Tilt --- This function resets pan and tilt.
Colour System --- This function resets colour wheels.
Gobo System --- This function resets static and rotating gobo wheels.
Dimmer/Strobe --- This function resets dimmer/strobe module.
Focus/Zoom/Frost --- This function resets focus,zoom and frost.
Iris/Prism --- This function resets iris and rot.prism.
9.9 Special functions
Use this menu for special services like adjusting lamp or adjusting effects.
Lamp Adjustment --- This function can be used when you make the fine adjustment of the lamp.If you select this
function,all effects will be canceled,shutter will be opened and the dimmer intensity will be set onto 100%.By
using the options "
PAn, Tilt, Zoom,Focus " you can focus the light on a flat surface (wall) and perform the fine
lamp adjustment.
Effect Adjustment --- By this function you can calibrate and adjust the effects to their standard/right
positions.Disconect the DMX controller from the fixture and select " DMX Values " menu.The display shows step
by step effects by which you can adjust the fixture to the required position before the function calibration. When
the positioning is finished ,select
"Calibrate Values" and press [ENTER]:
1. Calibration via the control board
Select desired effect, press [ENTER] and adjust its right value (0 - 255). This can be repeated for each calibred
effect if it is required. When the calibration is finished, it is necessary to use the
"Save and Reset" function to
write the calibration values to the memory and to make a reset in order to check the newly adjusted positions of
the calibrated effects.
List of the calibrated effects:
Colour Wheel 1 Static Gobo wheel Rot.Gobo Indexing
Colour Wheel 2 Rot. Gobo Wheel Iris
Dimmer
2. Calibration via the DMX controller
Connect the DMX controller to the fixture.Now you can calibrate the selected effect by your controller.
Effect Mode 1 Mode 2 Mode 3 Mode 4
Colour wheel 1 channel 28 channel 20 channel 30 channel 22
Colour wheel 2 channel 29 channel 21 channel 31 channel 23
Static gobo wheel channel 30 channel 22 channel 32 channel 24
Rot. gobo wheel channel 31 channel 23 channel 33 channel 25
Rot.gobo indexing channel 32 channel 24 channel 34 channel 26
Iris channel 33 channel 25 channel 35 channel 27
Dimmer channel 34 channel 26 channel 36 channel 28
After having calibrated required effects ,use the "Save and Reset" function to write the calibration values to the
memory and to make a reset in order to check the newly adjusted positions of the calibrated effects.
10. Power down mode
This mode omits fixture reset after switching the fixture on and lowers motor powers of the fixture.The "Power
down mode" is useful in special casech.g. if the fixture is in a flight case and you want to set its DMX address
without taking it out from the case.To enter "Low power mode":
Press and hold [ENTER] and at the same time switch on the Power switch.The following message appears:
Realy Skip Initial Reset?
Escape/Enter
Press [ENTER] to activate the "Power down mode" without fixture reset.Now you can set features and behaviour
of the fixture by using "Fixture Address"menu and "Personality" menu.It is expected,that this mode will be exited
by switching the fixture off ,but if you want to go directly to "normal operation mode",execute any fixture reset.
Note: All motors (except pan and tilt motors) in "Power down mode" are deactivated and switching the lamp on
from the control panel is blocked.