Roadtrek 210 Chevrolet, Руководство пользователя

Страница: 41 / 84

ELECTRICAL SYSTEM
Doc No: 21906532 Rev: 07 Copyright © Roadtrek Motorhomes Inc. 2010 E - 2
110V / 12V INVERTER / CHARGER / DISTRIBUTION PANEL:
For your convenience when camping in parks with connections for 110V power, all our models have in the electrical
system a 110/12 volt distribution panel / inverter / charger. The inverter/charger provides 12 volt power for the
12 volt appliances and the inverter provides 110 volt power for the galley receptacle and the audio/video receptacle.
The inverter charger also charges auxiliary batteries present in the system to supply power for all the 12 volt appliances.
See “Floor Plan & Appliance Location” for the distribution/inverter/charger location. To open the distribution panel
simply pull the access door until the cover is released. All the 110 volt breakers and 12 volt fused circuits are
identified on the back side of behind the distribution panel access door.
EXTERNAL ELECTRICAL SOURCE CONNECTION:
Your vehicle is equipped with a heavy duty 30 amp. power cord that can be connected to an outside 110V
power source.
The power cord is stored in the storage compartment, (see picture G-P19) located behind the driver side rear tire.
NOTICE: Do not place heavy or sharp objects on the power cord.
A 30 to 15 amp. adapter is not included with your vehicle.
NOTICE: When connecting your system to an external power source, ensure that a properly equipped,
(three pronged) and functioning receptacle is used. If any type of spark or shock is detected, disconnect
from the source immediately and do not reconnect until the problem is corrected.
GENERATOR:
All service requirements are listed in the Onan Owner’s Manual.
The generator is located and accessed on the underside behind the rear axle of your vehicle.
CAUTION: When launching a boat, using your Roadtrek, it is very important to know that a generator must
not be submerged in water.
This will permanently damage the generator. If you cannot launch without
submerging the generator, an alternate method would be to use a boat launching service.
Notice: To prevent carburetor damage, add an approved fuel stabilizer to the fuel tank, then run your generator
for a minimum of one hour under load monthly.
Notice: The Onan generator is not compatible with E-85 (85% Ethanol) fuel. If the vehicle is equipped with a
generator, avoid the use of E-85 fuel.
BUILT-IN 110V HEAT PUMP/AIR CONDITIONER:
In addition to the operating instructions contained in the Manufacturer’s Owner’s Manual, the heat pump/air
conditioner should be started as follows when the optional generator is used:
1. Set the battery disconnect switch on the monitor panel to the “ON” position.
2. Start the generator and run for several minutes until warm.
3. Set thermostat setting above ambient temperature.
4. Turn thermostat control to the “low cool” position.
5. Turn fan to the ON position.
6. Adjust the thermostat cooler until the compressor starts.
7. Once compressor is running adjust the thermostat to desired setting. Your vehicle should be parked
as close to level as possible to maximize the air conditioner’s efficiency.
NOTE: The heat pump can be used to warm the motorhome on cool nights. For colder temperatures, below 40°F
(4°C), it is suggested that the propane furnace be used for heat.